2005-09-19

2005-09-19

I've modified the water pump housing to get rid of the water pump part! 😉

Thus now I can run an electric water pump easily, and take the strain off the engine when it's reaching for the 9k rpm mark…

😀

Now I need to get a set of steel rods to complete my bottom end, and make it pretty much bullet proof. Titan Motorsport do a nice Chrome Moly flywheel so I think that's where I'll be going to a flywheel. Then I need the whole lot re-balanced again! 🙁 But it's got to be done…

Need to get a 7 1/2" clutch that fits the 20XE flywheel, and a type 9 box too. Must start thinking about that I guess…

Leave a Reply